In my 27 years, I have heard these questions a lot: “Why is it so hard to find the top electrician for my electrical repairs? There are so many choices and my problem seems so easy, any electrician should be able to do it. Does it matter who I call? Aren’t all electricians the same? How do I find an expert electric man?” – Nick Shaeffer

The answer is no – not all Twitter, Google Plus.

It’s always easy to tell when summer rolls around.  The temperature outside soars, and so does your electricity bill.  Wouldn’t it be great if a top Dallas electrician could save you money on your electric bill?

Everyone knows why your bills get so expensive; you’re running your AC almost all the time.  In fact, the condenser for your air conditioning unit uses more electricity during the summer months than any other appliance in your home, even notorious energy hogs like your refrigerator. There are things an electrician can do to save you money, and electric safety tips you need to know to protect your home, business, and loved ones from disaster.

These days most people call an AC service company the minute an air conditioning problem comes up.   That isn’t always the correct move, though.  In my experience, about half of all the problems that arise with air conditioning systems are electrical problems.  Some of my best customers began using my service because I could help them figure out whether they should be calling an electrician or an HVAC technician to solve their problem.  Obviously, if the problem is the AC unit or condenser, an AC repairman is the way to go, but he doesn’t necessarily understand the details of your home or business electrical system.  There are a few things you should know about your air conditioner from the electrician’s point of view.

Let’s face it—halogen and incandescent headlight bulbs are a thing of the past. fanless, driverless LED headlight bulbs were used in this installation.

If your vehicle allows for horizontal adjustments, mark the distance between your headlight centers with two vertical lines of tape. These lines are important for projector headlights and/or lining up beam cutoff points. Repeat these tape lines for your other headlight.

6. Remove your headlight assembly if necessary, remove the current bulbs, and install your new LED bulbs. Check your owner’s manual for specific instructions on how to replace your headlight bulbs.

7. Depending on your vehicle, you may have to adjust your headlight beam before or after the assembly has been reinstalled. Your owner’s manual will explain how to adjust the beams. Align each headlight so that the top edge of the beam is at the same height as your horizontal line(s). If your headlights can be adjusted horizontally or produce two light cutoff points, use the vertical tape lines to align them properly.

3. Shake the vehicle to ensure that your suspension system is settled. For more precise adjustments, inflate all tires to their designated psi capacity and have someone sit in the driver’s seat. Also, make sure that your vehicle’s gas tank is at least half full.

4. Measure from the ground to the center of your headlight assembly where the bulb is located. This step must be done for all vehicles. If your vehicle allows for horizontal headlight adjustments in addition to vertical adjustments, it’s important that you also measure the distance between the centers of both headlight bulbs. The vehicle featured in this video allows for vertical headlight adjustments only; therefore, center lines aren’t necessary but are shown for demonstration purposes.

5. Turn on your low-beam headlights. Using painter’s tape, mark your headlight measurements on a flat wall. Measure from the ground up, and apply a horizontal line of tape to the wall; this line represents the top of your headlight beam. You can either apply one long, continuous line or small sections where the brightest areas of the headlight beams are shown.

If your vehicle allows for horizontal adjustments, mark the distance between your headlight centers with two vertical lines of tape. These lines are important for projector headlights and/or lining up beam cutoff points.