More Problems

Okay, so light pollution isn’t good. But perhaps you’re thinking, if we turn off the lights that illuminate our streets and sidewalks, homes and buildings, they’ll become dangerous. Car accidents are bound to increase on dark, busy streets, and walking on sidewalks out at night would be scary to say the least. Not to mention a poorly lit home is a target for sinister intruders.

So what do we do? Is there any sort of compromise?

New LED lighting offers some hope, but it’s certainly not all sunshine and rainbows.

How LED Light Can Help Decrease Light Pollution   

How LEDs May Add To Light Pollution

An electrical circuit works as a loop where electricity flows from a source and then returns to that point again after powering the device connected to it. The power flow interrupts or stops if the path is broken. There are also receptacles, fixtures, or switches joined to the course through different types of electrical wiring.

Every electrical circuit has a specific breaker or fuse that controls it. Inside the main electrical panel of your house, you will find reference numbers to identify which breaker or fuse is assigned to which circuit. Mapping of them is a standard electrical safety procedure.

power company supplies electricity to your home through the transmission and distribution lines. The energy enters the service panel, also known as the fuse or breaker box, after passing through a meter. Then, the box has three wires (hot, neutral, and ground featuring insulation of different colors) that do the jobs of transmitting the power to an external outlet, returning to the source, and providing the ground.

The wires of your home are generally installed in three ways:

It’s a wiring system where a single electrical circuit supplies power for several devices. There are various housing boxes from where both hot and neutral wires emerge and run along the route. They branch off to single receptacle and fixture.

It’s the most common of all the systems seen in residential settings.

Switch Wiring

Installed on hot wires, such a system has switches that either transmit or break the current flow to various devices or lighting fixtures. A switch changes its position to allow or interrupt the flow of electricity to electrical machines and instruments.

The system routes the hot wire through various fixtures before joining to the neutral one, which then carries the power to the source. It’s the least used and most inconvenient of all the types because it connects the devices, i.e., lights in a series. So, the circuit breaks off when just one light is burnt out.

Parallel wiring is the best option for household settings because it does not break even when one of the connected fixtures goes kaput. Nevertheless, remember not to run too many electronics from one source because each circuit can carry only a maximum electrical flow.