2. In order to open the headlight housing, it must be heated to soften the glue that seals it. Preheat the oven to 270 degrees Fahrenheit, and place the housing in the oven (top rack). Heat the housing for approximately seven minutes. Note that this time will vary by vehicle manufacturer and that you should be careful not to overheat your assembly. Also note that the headlight will be hot when removing it from the oven, so take care not to burn yourself.

*Please note that this can damage your headlight assembly and that you do so at your own risk.

4. LED angel eye installation will vary by headlight. In this instance, we mounted an

5. Place the second layer back in the housing to ensure that everything is aligned the way you would like. This is also a great time to clean the inside housing, as you will not be able to do so once you reseal it. The cleaner you get it the better; smudges and dirt will be more visible when the lights are on.

8. Now it’s time to reseal the headlight housing. Preheat the oven to 270 degrees again, place the layers together, and put the headlight in the oven (with halo rings installed) for seven minutes. Remove the headlight from the oven, and press the layers together firmly as you work around the lens to ensure all of the edges are sealed (this might require gloves, as the headlight will be somewhat hot). Be careful to only press on the edges so as not to warp the lens.

*Please note that this can damage your headlight assembly and that you do so at your own risk.

10. With the headlight housing installed, complete your wiring, and test connections to ensure proper installation. Be sure to tape/heat-shrink any wiring connections that were added, and clean up any loose wiring.