As we near the end of summer, we’re still contending with temperatures in the 90 degree region. As a result, we are using our air conditioners for the majority of the day, every day. This puts a lot of strain on your electricity, which is probably reflected on your summertime utility bills. The good news is, there are a number of ways in which you can save energy, and thus reduce your electric bills. We’ve cited a few examples below.

This is a task that should be done at least on a yearly basis—bi-annually if you have a heat pump. You’ll hear some companies tell you that you can or should only have AC maintenance done before the cooling season begins. The truth is however, that AC maintenance can be done at any time of the year (though it is true that HVAC technicians are busier and harder to schedule at peak temperatures).

Preventive maintenance allows our technicians to fully inspect and clean your AC system, and make recommendations for any repairs that might be needed. When your system is effectively cleaned and repaired, it performs more efficiently, and therefor doesn’t use up as much energy as it normally would.

The Department of Energy estimates that 75% of the electrical use by your electronics occurs when those electronics are actually not in use. While there may only be a small amount of electricity used by each component, it adds up. We recommend that you plug each of your electronics into a power strip, and then when they aren’t in use, turn the power strip off.

This is a maintenance task that you can do on your own, at least every 3 months while your system is in use. If you have significant contaminants in your home, such as pet dander or cigarette smoke, then you should up this to once a month. If your air filters are clean, then your air conditioner won’t have to work as hard or run as long to do its job, which means it won’t be using up as much energy as usual.

As you can see, no matter which type of scenario that lighting comes up in; it matters. Whether you run an office or a huge industrial sized factory; the quality of your lighting is highly important.

We are going to list the most important points that qualifies “good” industrial lighting systems, what to watch out for, as well as what to be on the look out for when it comes to your commercial lighting purchases.

Quality of light being produced. The quality of light that your lighting system will make or break your lighting system investment. If you cheap out initially and go with cheaper light sources such as HPS, you will regret it in the long run. Not only does LED typically offer a better CRI score, but it has many other benefits such as…

Do you want rebates for your lighting investment? If so; buy DLC qualified.

Conclusion

Whole-home surge protectors are designed to protect your home from dangerous lightning strikes that could knock out power or fry your electronics, potentially resulting in thousands of dollars in damages.  Recently, however, there has been a lot of controversy surrounding whole-home surge protectors, claiming they’re a waste of money and don’t do what they claim to be able to do. So what’s the real story here? Are whole home surge protectors worth it?

We’ll start by talking about what surge protectors are not designed for: protecting your home from all sources of increased voltage. Power surges most commonly originate inside your home as a result of different appliances turning on and off. Depending on your home’s electrical service (100amp vs 200amp or whatever you may have), you’ve probably seen this in the form of flickering lights when your air conditioner cycles on.

Whole-home surge protectors do protect your home from power surges that originate outside, commonly caused by lightning strikes but also resulting from any interruptions to the power: downed wires or utility poles, wind damage, utility repairs, etc.

There are a few different ways power surges can occur. Lightning strikes, which people tend to be most worried about, are actually pretty uncommon—conditions need to be perfect, and the strike needs to occur less than one mile away from your home. Despite their rarity, lightning strikes can send a 200,000-amp jolt through your home and are definitely not to be taken lightly.

The majority of external power surges occur when the magnetic field created by wires conducting electricity collapses, which sends large voltages down the wires and eventually, into homes and buildings.

Effectively defending your home from power surges requires a two-step approach: first, outfitting it with a whole-home surge protector, then using surge-protected outlets and power strips indoors. Both types of surge protectors act essentially like pressure relief valves, diverting excess energy away and restoring normal operation once levels regulate.

Whole-home surge protectors are usually wired to a service panel and are designed to stop surges of at least 40,000 amps, though larger ones can be installed. Pairing them with individual plug-in surge protectors should do a good job of catching any potentially damaging energy that may get into your home.

Like many safety-related things, whole-home surge protectors are appliances you buy and hope to never actually use. But all it takes is a single downed line or big lightning strike to cause thousands of dollars’ worth of damage to your home—not worth the risk!

If you want to protect your home from dangerous jolts of electricity by installing a whole-home surge protector, call Kolb Electric today!

Basements are excellent spaces for storing things you don’t want taking up space on the main floors of your home. Unfortunately, it doesn’t take long before the basement becomes a bit of a catch-all and gets crowded. The lack of proper lighting and the walls in general don’t make the space very appealing, so it seems like the only thing it is really good for is hiding your storage. What if you could add spruce up the basement, even just half of it and make it a little more inviting? Would you do it? An electrician in Los Angeles can help you transform the dark space into one that looks beautiful and is filled with light. The team at The Electric Connection wants to help you do just that.

One of the biggest problems you will find in a basement is the lighting. It is either way too dark or way too brightly lit with some garish shop lights that will blind you if you look directly at them. The lights tend to leave a yellow glare on everything and it is just unpleasing overall. Imagine being able to step down those stairs into a room with carpeting or vinyl, paint on the walls and beautiful lighting that gives the room an inviting feel. Your Los Angeles electrician can really do that—the lighting part of it anyways. Really, the lighting is one of the most important details. It can make or break a space.

Basements are tough to work with because of the lack of natural light and the low ceilings. In order for the space to look big and bright, recessed lights should be installed by an electrician. Los Angeles homeowners will love how much light there is in the space. Another perk is they are not going to lose any ceiling space. The lights are recessed right into the ceiling so you don’t have to worry about your tall friend hitting his head. Give The Electric Connection a call today and schedule your basement lighting installation.